More putty work and a Dungeon Saga figure

So the putty work continued this week.

All ready for primer

Up first was the wing claw of the GW LotR Balrog.  This had been snapped off at some stage.  First up I drilled and glued in a paper clip shaped the rough curve of the other claw and then covered it in Milliput.  Once dry I carved this down to match the existing claw.  After that I sanded the Milliput with 320 and then 600 grit sand paper to smooth out the surface as the existing plastic claw is very smooth of course.

Redone claw

I then dropped the figure and chipped off the end of the claw.  So I switched to green stuff as it is more flexible and redid the tip of the claw (unfortunately not as sharp) and added in some more knuckle shapes, etc.  Calling it done at this stage.

Final thing was drilling and pinning the feet for attaching to the base.

Two joins only - take that Balrog

I also did a bit of green stuff work on some Reaper Bones figures I purchased to cover up the join marks.  Nothing major there.

I had planned to start priming all these figures but the weather has been too wet whenever I'm at home and the shed does get a bit cold and humid so decided to wait a bit.

Dungeon Saga figure

Finally actually did some painting and worked on the Kickstarter exclusive figure from the Dungeon Saga kickstarter.  Kind of need a small figure to get back into things after near two months with very little painting.